Concrete Patch

Contact Us for Price

SKU: ML820 Category:
 

Description

40 LBS

ML820 CONCRETE PATCH is a 100% solids epoxy compound used with a dry, salt-free sand for repairing cracked or spalled concrete floors, pump pedestals, curbs, and areas of heavy wear such as thresholds and loading ramps. Concrete Patch is approved by the USDA for use in food processing plants. It provides excellent abrasion and impact resistance as well as good chemical resistance. This product contains no volatiles. It applies very easily. More than just a surface coating… Concrete Patch actually bonds concrete together. The tensile strength is over 5 times that of concrete!

TECHNICAL DATA:

Working and curing times:

Application Temperature Range:………………………………..…………45º to 100ºF

Mixing ratio:………………………………………….………………… 4:1 by volume

Pot Life @ 70ºF:…………………………………..……………………….15-30 minutes

Recoat Time:…………………………………..………………………4-24 hours @ 75ºF

Cure Time:…………..Ready for light traffic: 4-5 hours, Heavy traffic: 18-24 hours

Coverage:…Ten pounds of blended Concrete Patch will cover 5 sq. ft @ 1/4″ thick

Color:……………………………………………………………………………………………..Gray

Compression Strength: Concrete Patch: 8200psi Concrete: 3500psi

Tensile Strength: 2500psi 375psi

Hardness Rockwell M: 80 60

Impact Strength: 4X X

Shrinkage inch/inch: .0005 .03

Bond Strength:………………………Stronger than concrete per ACI test 59-43

Chemical Resistance: 

Sulfuric Acid- 30%, Nitric Acid-10%, Citric Acid-5%, Ammonium Hydroxide-20%, Sodium Hydroxide-20%, Jet Fuel, Fresh and Salt Water, Hydrochloric Acid-10%, Acetic Acid-10%, Phosphoric Acid-10%, Potassium Acid-10%, Potassium Hydroxide-20%, Gasoline, Xylene, Mineral and Vegetable Oil.

DIRECTIONS FOR USE:

(Note: new concrete must be cured at least 28 days before applying Concrete Patch)

1. Follow concrete Surface Preparation Guide to assure all loose and unsound concrete, contaminants, and other foreign deposits are removed.

2. If the surface is rough or porous, apply an initial primer coat to the surface using METALINK ML819 Concrete Primer/Sealer. Allow to cure according to directions. (Concrete Patch will need to be applied while Concrete Primer/Sealer is still tacky.)

3. Add 4 parts Base (Part A) to 1 part hardener (Part B) by volume (or all of both containers if entire batch is being used). Mix well using a power mixer for approximately 2 minutes.

4. Slowly add sand while continuing to mix, until a uniform blend is achieved. Total mixing time should be at least 3 minutes.

5. Pour mixture out of container and on to the primed substrate. Spread by using a hand trowel, screed or machine trowel. Apply pressure to compact the Concrete Patch to a dense, tight finish.

WARNING: This product is a potential skin sensitizer. May cause injury to eyes and skin following prolonged or repeated contact. Inhalation of vapor may cause respiratory tract irritation. Use adequate ventilation when applying to avoid inhalation of vapor. Prevent contact with eyes and skin. Read and understand M.S.D.S. sheet. We can accept no responsibility or liability for lack of results because the storage, handling, and application of the compound is beyond our control.

Additional information

Weight 3 lbs

Product Enquiry