Concrete Primer and Sealer

Contact Us for Price

SKU: ML819 Category:
 

Description

1.5 GALLON

ML819 CONCRETE PRIMER/SEALER is a 100% solids, solvent free epoxy compound designed for use either as a stand-alone sealer or as an undercoat for Concrete Patch and Slip-Not. It is approved for use in food processing plants. It has been formulated to provide deep penetration into the surface without the use of solvent, thus eliminating any objectionable solvent odor, particularly inside buildings or around food processing or storage areas. It fills small voids and hairline cracks, and helps seal air entrained concrete to prevent “out gassing”. Concrete Primer/Sealer is also a stand-alone concrete sealer which can be applied in one or two coats and provides a tough, durable, hard film which prevents dusting and deterioration of concrete surfaces and the effects of water, chemicals or freeze/thaw cycles. This product can be applied to damp or moist surfaces without affect to performance.

DIRECTIONS FOR USE:

1. Follow concrete Surface Preparation Guide to assure all loose and unsound concrete, contaminants, and other foreign deposits are removed.

2. Add 2 parts Base (Part A) to 1 part hardener (Part B) by volume (or all of both containers if entire batch is being used). Mix well using a power mixer for approximately 2 minutes.

3. For best results, apply by roller, using a medium nap, phenolic core roller cover. Apply an even, wet film while working material into surface. Do not allow material to puddle.

4. Spread rate will be approximately 200 to 400 square feet per mixed gallon, depending upon porosity of concrete surface.

5. Concrete Primer/Sealer can also be sprayed applied, followed by “back-rolling” the material into the surface, or be applied by squeegee. Small areas can be brushed using a pure Chinese bristle brush.

TECHNICAL DATA:

Working and curing times:

Application Temperature Range:……………………..45º to 120ºF

Mixing ratio:………………………………………………2:1 by volume

Pot Life @ 75ºF:………………………………………….20-30 minutes

Recoat Time (as primer):……………………….(@ 75ºF): 1/2-6 hours

Maintain a “tack” Do not allow to dry before applying Concrete Patch or Slip-Not

Cure Time (as sealer):…………………………………….18- 48 hours

Coverage: ……………….200-400 sq. ft per gallon @ 6-10 mils thick

Color: ……………………………………………………………………….Light Grey

WARNING: This product is a potential skin sensitizer. May cause injury to eyes and skin following prolonged or repeated contact. Inhalation of vapor may cause respiratory tract irritation. Use adequate ventilation when applying to avoid inhalation of vapor. Prevent contact with eyes and skin. Product is combustible. Keep away from all sources of ignition during storage, mixing, application and cure. Read and understand M.S.D.S. sheet. We can accept no responsibility or liability for lack of results because the storage, handling, and application of the compound is beyond our control.

Additional information

Weight 4 lbs

Product Enquiry